|
|
|
|
|
|
SunSetter Flagpoles Technical Support |
|
Home
Telescoping Flagpole  Installation Instructions Operating Instructions Troubleshooting Parts List and Diagram Replacement Parts Instructions
Deluxe 6 Foot Flagpole Installation Instructions Parts List and Diagram Installation Instructions Parts List and Diagram Troubleshooting |
How to Use Your Flagpole
To Raise the Pole Pull each section up slowly until automatically locked, starting from the top inner section. To Lower the Pole CAUTION: Hold on to the section to be lowered. Press the locking button (see Figure 1) to release, and allow the section to slide down slowly through your hands. 
To Secure each Section in the Extended Position with the Optional Childproof Lock 1. A small bag that contains the "childproof" Allen screw locks for the section bushings and ground sleeve collar, as well as a 5/64" Allen wrench is included with each flagpole. Install one short "childproof" Allen screw lock in the threaded hole of each top bushing of every pole section. 2. Using the Allen wrench supplied, turn the screw lock 3 complete turns to secure the desired position. Do NOT overturn. (See Figure 1) CAUTION: Before releasing the push button to lower each section, unlock the Allen screw so the head of the screw is flush with the outside edge of the bushing. Failure to do so could result in the pole being scratched. Prior to Using the Optional Locking Ground Sleeve Feature 1. Insert the pole into ground sleeve. 2. Install one long "childproof" Allen screw lock in the threaded hold of the ground sleeve collar. 3. Tighten the Allen screw lock against the pole to make a mark (See Figure 2). 4. Loosen the Allen screw lock and remove the pole from the sleeve. 5. CAUTION: Extend the second section from the bottom at least 2 feet to prevent drilling through both poles. 6. Center punch at the mark left by the screw lock, and using a 3/16" drill bit, drill a hole through one wall of the outer section. To Secure the Pole to the Ground Sleeve 1. Align the drilled hole in the pole with the Allen locking screw lock in the locking collar. 2. Using the Allen wrench supplied, turn the screw lock 4 complete turns to secure the collar to the pole. Do NOT overturn. (See Figure 2). CAUTION: Do Not Use Any Silicone Lubricants |
|
| Owner's Corner Main Menu |
| | Awning Home Page |
| | Flagpole Home Page |
| | Contact Us |
|
Copyright © 2010 SunSetter Products,
a Massachusetts Limited Partnership. All rights reserved. All trademarks are owned by SunSetter Products. |
For technical support please |
|
|
