|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
Tools Needed:
Parts Supplied: 1. Remove the top section of the pole by holding in the middle button while extending the section upwards and sliding the top section out of tube #2 2. Remove tube #2 from tube #3 by first lifting tube #2 until the button lucks. Next depress the button and remove tube #2 completely out of tube #3. 3. Place the new tube #2 back into tube #3. Lower it slowly until the button pops out of the hole in tube #3. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 4. Place tube #1 back into tube #2. Lower it slowly until the button pops out of the hole in tube #2. Be sure to line up the slot in the bottom cap with the track on the inside of the inside of the tube. 5. Test the flagpole for proper operation. |
|
| Owner's Corner Main Menu |
| | Awning Home Page |
| | Flagpole Home Page |
| | Contact Us |
|
Copyright © 2010 SunSetter Products,
a Massachusetts Limited Partnership. All rights reserved. All trademarks are owned by SunSetter Products. |
For technical support please |
|
|
