|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
Tools Needed:
Parts Supplied: 1. Remove the top two sections of the pole by holding in the middle button while extending the two sections upwards and sliding them out of tube #3. 2. Remove tube #3 from tube #4 by first lifting tube #3 until the button locks. Next depress the button and remove tube #3 completely out of tube #4. 3. Place the new tube #3 back into tube #4. Lower it slowly until the button pops out of the hole in tube #4. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 4. Place the two top sections back into tube #3. Lower them slowly until the button pops out of the hole in tube #3. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 5. Test the flagpole for proper operation. |
|
| Owner's Corner Main Menu |
| | Awning Home Page |
| | Flagpole Home Page |
| | Contact Us |
|
Copyright © 2010 SunSetter Products,
a Massachusetts Limited Partnership. All rights reserved. All trademarks are owned by SunSetter Products. |
For technical support please |
|
|
