|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
Tools Needed:
Parts Supplied: 1. Remove the top three sections of the pole by holding in the bottom button while extending the section upwards and sliding the top three sections completely out of tube #4. 2. Remove the bottom cap mounting screws and remove the bottom cap. 3. Align the slot in the bottom cap with the track inside the tube and slide the new bottom cap into the tube. 4. Install the two new bottom cap mounting screws. 5. Place the top three sections of the pole back into tube #4. Lower them slowly until the button pops out of the hole in tube #4. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 6. Test the flagpole for proper operation. |
|
| Owner's Corner Main Menu |
| | Awning Home Page |
| | Flagpole Home Page |
| | Contact Us |
|
Copyright © 2010 SunSetter Products,
a Massachusetts Limited Partnership. All rights reserved. All trademarks are owned by SunSetter Products. |
For technical support please |
|
|
