|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
|
|
|
|
|
| SunSetter Flagpoles Technical Support |
|
Tools Needed:
Parts Supplied: 1. Remove the top two sections of the pole by holding in the middle button and extending the sections upwards and out of pole # 3. 2. Remove the tube #3 clear bushing by depressing the two clear tabs while pulling the clear bushing up and out of the pole section. Note the alignment of the old bushing. 3. Align and insert the new clear bushing into the tube section. 4. Place the top two tube sections back into the main tube assembly. Lower them slowly until the button pops out of the hole in tube 3. Be sure to line up the slot in the bottom cap with the track on the inside of the tube. 5. Test the flagpole for proper operation. |
|
| Owner's Corner Main Menu |
| | Awning Home Page |
| | Flagpole Home Page |
| | Contact Us |
|
Copyright © 2010 SunSetter Products,
a Massachusetts Limited Partnership. All rights reserved. All trademarks are owned by SunSetter Products. |
For technical support please |
|
|
