TUBE 3 SPRING BUTTON REPLACEMENT

1. Remove the top sections of the pole by holding in the middle button while extending the section upwards and sliding the top two sections out of tube #3.

2. Remove tube #3 from tube #4 by first lifting tube #3 until the button locks. Next, depress the button and remove tube #3 completely out of tube #4.

3. Remove the two bottom end cap screws and remove the bottom cap.

4. Remove the screw located next to the spring button. Depress the spring button into the tube assembly if it is not already depressed.

5. Position the pole vertically so that the spring button is at the bottom. Drop a screwdriver, handle first, down the inside of the pole to knock the button assembly out.

6. Install the new button assembly into the bottom end of the pole, flat side first. Be sure the groove in the button assembly is aligned with the track inside the tube. Use a long screwdriver to maneuver the button into its resting-place, with the button popping out of the hole.

7. IMPORTANT: Reinstall the assembly mounting screw.

8. Reinstall the bottom end cap with the two mounting screws.

9. Place tube #3 back into tube #4. Lower it slowly until the button pops out of the hole in tube #4. Be sure to line up the slot in the bottom cap with the track on the inside of the tube.

10. Place tube #’s 1 and 2 back into tube #3. Lower them slowly until the button pops out of the hole in tube #3. Be sure to line up the slot in the bottom cap with the track on the inside of the tube.

11. Test the flagpole for proper operation. The button should automatically pop into the hole as you raise the section.

To print this section click here.

Owner's Corner
Main Menu

Awning
Home Page

Flagpole
Home Page

Contact
Us

For technical support please
call 800-670-7071 8:00AM to 10:00PM EST seven days a week

Click here for BBB Business Review